so here is some of the fun stuff i found that the previous previous owner did.. im going to name a couple things besides the plasti dip...
1.tighten the risers to much and welded the threads back on
2.welded brake line tubes to the inside of the rear fender to run his LED (house speaker) wire through inside of using the stock wire clamps.. (no picture)
3.lost a lot of bolts and screws, and replaced them with well whatever he had laying around.
4.installed alum. grips, but used a sheet metal screw to hold them in place. yes screwed right through the grip to the bars.....
5.THE BEST.. cut the stock exhaust, welded on turn out tips that were 4x to big, wrapped the entire exhaust 3 times over and used, chicken wire, hose clamps, and cut up coat hangers to tie the wrap down... (pic with no wrap just bare exhaust)
6. im sure there is more but at this point i can't think of anything else.